1mm x 8mm x 4mm x 50mm AlTiSin Coated Carbide 4 Flute Square End Mill 2pcs End Caps Please Note: Backing Pad is

Please Note: Backing Pad is not included here

5mm x 31mm x 69mm / 2

Hook Mount Hole Diameter: 3mm / 0

1 x Rubber Seal Strip

4" x 3"(L*W*H)

1mm x 8mm x 4mm x 50mm AlTiSin Coated Carbide 4 Flute Square End Mill 2pcs End Caps Please Note: Backing Pad isMade of super fine grain carbide, the end mill cutter has high hardness (HRC92), high strength, and wear resistance. With good milling and cutting performance, carbide can run at higher speed than high speed steel. Features square end cut, 4 flute design, large and spiral chip space design for fast and clean chip removal. Sharp cutting edge provides smooth cutting. The AlTiSin composite coating has high hardness, high wear resistance and high thermal