Pay in 4 interest-free payments of $24.88 Learn more
Ships within 48 hours · Estimated delivery Sep 13 - Sep 18
When performing a Danfoss KP1 setup
It features a 3/4" NPT connection and is rated for a maximum inlet pressure of 1/2 PSI
this 6-inch probe uses the same sensing technology as the duct series
and always apply fresh thermal paste to the heat sink interface to prevent premature component failure due to overheating
Durable Construction: Engineered to withstand the demands of industrial environmental monitoring
Eaton Cutler-Hammer H2011B-3 Heater 320734-701 When performing a Danfoss KP1The Eaton Cutler Hammer H2011B 3 Heater is an industrial grade thermal overload component engineered for the Eaton Freedom Series and Definite Purpose motor starters. This set of three heater packs provides critical motor overload protection by monitoring the current draw and initiating a trip if thermal limits are exceeded. Designed for precise Full Load Amp (FLA) calibration, the H2011B 3 supports an adjustable range from 9. 14 to 14. 0 Amps. As a